Turbolinux Workstation 8

Support

This guest operating system is supported on the following VMware products:

General Installation Notes

Be sure to read General Guidelines for All VMware Products as well as this guide to installing your specific guest operating system.

The easiest method of installing Turbolinux Workstation 8 in a virtual machine is to use the standard Turbolinux distribution CDs. The notes below describe an installation using the standard distribution CD; however, installing Turbolinux Workstation 8 via the boot floppy/network method is supported as well. If your VMware product supports it, you may also install from a PXE server.

Before installing the operating system, be sure that you have already created and configured a new virtual machine.

Caution: During the Turbolinux Workstation 8 installation, do not install an X server. To get an accelerated SVGA X server running inside the virtual machine, install the VMware Tools package immediately after installing Turbolinux Workstation 8.

Installation Steps

  1. Insert the Turbolinux Workstation 8 installation CD in the CD-ROM drive.
  2. Power on the virtual machine to start installing Turbolinux Workstation 8.
  3. Follow the installation steps as you would for a physical machine, until you get to the selection screens described in the next steps.
  4. Install using the text mode installer. In the first installation screen, press the F2 key, then press Enter to select the text mode installer.
  5. When prompted, do not install an X server. In the Desktop Settings screen, choose Text Mode Only. Click Accept and finish the installation.

VMware Tools

Be sure to install VMware Tools in your guest operating system. For details, see the manual for your VMware product or follow the appropriate link in the knowledge base article at www.vmware.com/support/kb/enduser/std_adp.php?p_faqid=340.

Do not start the X server in the guest operating system until you install VMware Tools and run the SaX2 configuration utility. See Before You Start the X Server below.

Before You Start the X Server

After you have installed VMware Tools, but before you start the X server, as root user, run the SaX2 configuration utility to configure your X server. At a command prompt, type SaX2 and use the wizard to configure your X server.

GSX Server: If you intend to connect to this virtual machine with the VMware Virtual Machine Console, configure the color resolution for 65536 (16-bit) colors or less.

After you run SaX2 you may boot your Turbolinux Workstation 8 virtual machine with any of the selections offered in GRUB.

Enabling Sound After Installing Turbolinux Workstation 8

GSX Server: The sound device is disabled by default and must be enabled with the virtual machine control panel (VM > Settings) after the operating system has been installed. To set up the virtual machine to play sound, see Configuring Sound in the GSX Server documentation.

Known Issues

Guest Screen Saver

On a Linux host with an XFree86 3.x X server, it is best not to run a screen saver in the guest operating system. Guest screen savers that demand a lot of processing power can cause the X server on the host to freeze.