Return-Path: <scs@eskimo.com>
Received: from fort-point-station.mit.edu by po11.mit.edu (8.9.2/4.7) id KAA19180; Thu, 18 Jul 2002 10:41:03 -0400 (EDT)
Received: from mail.eskimo.com (mail.eskimo.com [204.122.16.4])
	by fort-point-station.mit.edu (8.9.2/8.9.2) with ESMTP id KAA26197;
	Thu, 18 Jul 2002 10:40:10 -0400 (EDT)
Received: from eskimo.com (scs@eskimo.com [204.122.16.13])
	by mail.eskimo.com (8.9.1a/8.8.8) with ESMTP id HAA20579;
	Thu, 18 Jul 2002 07:40:08 -0700 (PDT)
From: Steve Summit <scs@eskimo.com>
Date: Thu, 18 Jul 2002 10:40:08 -0400
Received: manually from box16 by eskimo.com; Thu, 18 Jul 2002 07:05:15 -0800
X-Original-Date: Wed, 17 Jul 2002 23:10:05 -0400
Message-Id: <2002Jul17.2310.scs.0014@box16.scs.ndip.eskimo.net>
To: in-house-pikans@mit.edu, summer-pikans@mit.edu
Subject: Re: sterilizer status
References: <2002Jul16.0940.scs.0016@box16.scs.ndip.eskimo.net>
Cc: scs@eskimo.com

I wrote:
> The drain cycle is supposed to work, I think, by running the
> pump motor but then opening a solenoid so that the water is...
> diverted straight down the drain.  ...the likely problems are
> the logic module, or simply the part of the on-off switch that
> initiates the drain cycle.  The latter is more likely and
> should be very easy to replace...

I thought I had it all figured out.  If it was the
easy-to-replace switch that was bad, voltage should fail to
appear at a certain terminal, explaining why the drain cycle
wouldn't start.  So I opened it up again, and connected my
voltmeter to that terminal, and pushed the "Drain" button.

And Herr Heisenberg was with me...

Not only did the voltage appear (like I didn't expect it to),
but the drain cycle commenced, too!

So the drain cycle *does* work, at least some of the time.

Happy dishwashing; I'll shut up now.
