Reading Your Mail

The mh-e entry point for reading mail is M-x mh-rmail. This command incorporates your mail and creates a buffer called `+inbox' in MH-Folder mode. The M-x mh-rmail command shows you only new mail, not old mail. (7) The `+inbox' buffer contains scan lines, which are one-line summaries of each incorporated message. You can perform most MH commands on these messages via one-letter commands discussed in this chapter. See scan(1) for a description of the contents of the scan lines, and see the Figure in section Receiving Mail, for an example.

RET

Display a message (mh-show).

SPC

Go to next page in message (mh-page-msg).

DEL

Go to previous page in message (mh-previous-page).

, (comma)

Display a message with all header fields (mh-header-display).

M-SPC

Go to next message in digest (mh-page-digest).

M-DEL

Go to previous message in digest (mh-page-digest-backwards).

M-b

Break up digest into separate messages (mh-burst-digest).

n

Display next message (mh-next-undeleted-msg).

p

Display previous message (mh-previous-undeleted-msg).

g

Go to a message (mh-goto-msg).

M-<

Go to first message (mh-first-msg).

M->

Go to last message (mh-last-msg).

t

Toggle between MH-Folder and MH-Folder Show modes (mh-toggle-showing).

• Viewing
• Moving Around

Go to the first, previous, next, last section, table of contents.