The following is a sample Linux vmnetnat.conf file.

# Linux NAT configuration file

[host]

# NAT gateway address

ip = 192.168.237.2/24

hostMAC = 00:50:56:C0:00:08

# enable configuration; disabled by default for security reasons

#configport = 33445

# VMnet device if not specified on command line

device = VMnet8

# Allow PORT/EPRT FTP commands (they need incoming TCP stream...)

activeFTP = 1

# Allows the source to have any OUI. Enable this if you change the OUI

# in the MAC address of your virtual machines.

#allowAnyOUI = 1

[udp]

# Timeout in seconds, 0 = no timeout, default = 60; real value might

# be up to 100% longer

timeout = 30

[incomingtcp]

# Use these with care - anyone can enter into your virtual machine through

# these...

# FTP (both active and passive FTP is always enabled)

# ftp localhost 8887

#8887 = 192.168.27.128:21

# WEB (make sure that if you are using named webhosting, names point to

# your host, not to guest... And if you are forwarding port other

# than 80 make sure that your server copes with mismatched port

# number in Host: header)

# lynx http://localhost:8888

#8888 = 192.168.27.128:80

# SSH

# ssh -p 8889 root@localhost

#8889 = 192.168.27.128:22

[incomingudp]

# UDP port forwarding example

#6000 = 192.168.27.128:6001