This guest operating system is supported on the following VMware products:
Note: If you are installing a guest operating system through VMware VirtualCenter, be sure it is supported under the VMware product - ESX Server or GSX Server - on which you are running the virtual machine.
Be sure to read General Guidelines for All VMware Products as well as this guide to installing your specific guest operating system.
The easiest method of installing Turbolinux Enterprise Server 8 (TLES 8) in a virtual machine is to use the standard Turbolinux distribution CDs. The notes below describe an installation using the standard distribution CD; however, installing TLES 8 via the boot floppy/network method is supported as well. If your VMware product supports it, you may also install from a PXE server.
Before installing the operating system, be sure that you have already created and configured a new virtual machine.
Caution: During the TLES 8 installation, do not install an X server. To get an accelerated SVGA X server running inside the virtual machine, install the VMware Tools package immediately after installing TLES 8.
Be sure to install VMware Tools in your guest operating system. For details, see the manual for your VMware product or follow the appropriate link in the knowledge base article at www.vmware.com/support/kb/enduser/std_adp.php?p_faqid=340.
Do not start the X server in the guest operating system until you install VMware Tools and run the SaX2 configuration utility. See Before You Start the X Server below.
After you have installed VMware Tools, but before you start the X server, as root user, run the SaX2 configuration utility to configure your X server. At a command prompt, type SaX2 and use the wizard to configure your X server.
GSX Server: If you intend to connect to this virtual machine with the VMware Virtual Machine Console, configure the color resolution for 65536 (16-bit) colors or less.
After you run SaX2 you may boot your TLES 8 virtual machine with any of the selections offered in GRUB.
GSX Server: The sound device is disabled by default and must be enabled with the virtual machine control panel (VM > Settings) after the operating system has been installed. To set up the virtual machine to play sound, see Configuring Sound in the GSX Server documentation.
On a Linux host with an XFree86 3.x X server, it is best not to run a screen saver in the guest operating system. Guest screen savers that demand a lot of processing power can cause the X server on the host to freeze.